Transition Properties

Property Name	Description
Connection 1 \| Length (L1)	`Positive <numeric value>` Sets the straight length at End1.
Connection 2 \| Length (L2)	`Positive <numeric value>` Sets the straight length at End2.
Connection \| End Type	fl `-<numeric value>` Sets and sizes end with a flange connection. m `-<numeric value>` Sets and sizes end with a male connection. fe `-<numeric value>` Sets and sizes end with a female connection. Separate End Type entries for each End Spec with a semi colon. Example: fl-2;fe-.13 creates a flange at End1 with size 2, and a female connection at End2 with an overall reduction of component's dimensions of .13
Inline Length	`Positive <numeric value>` Sets overall length of fitting.
Radius1–1	`Positive <numeric value>` Sets the radius size on the top portion of the fitting close to End1.
Radius1–2	`Positive <numeric value>` Sets the radius size on the bottom portion of the fitting close to End1.
Radius2–1	`Positive <numeric value>` Sets the radius size on the top portion of the fitting close to End2.
Radius2–2	`Positive <numeric value>` Sets the radius size on the bottom portion of the fitting close to End2.
Rise	`<numeric value>` Sets the top to bottom offset. Limited by Offset Options property. Sets the offset distance between the Rectangular Ogee's two inline branches. Sets the top to bottom offset between the oval/round ducts/fittings.
Run	`<numeric value>` Sets the right to left offset. Limited by Offset Options property.
Offset Options	`<null value>` Frees fitting from any symmetry constraints. a `<angle value>` Face is offset by an angle value. a< `<angle value>` Changes the default minimum angle check of 5° to the New Value. b Bottom is flat. b `<numeric value>` Bottom is offset by value. ba `<angle value>` Bottom is offset by an angle. `l` Left side is flat. l `<numeric value>` Left side is offset by value. la `<angle value>` Left side is offset by an angle. r Right side is flat. r `<numeric value>` Right side is offset by value. ra `<angle value>` Right side is offset by an angle. s Fully symmetric fitting. st Symmetric fitting with respect to top and bottom. sr Symmetric fitting with respect to left and right. t Top is flat t `<numeric value>` Top is offset by value. ta `<angle value>` Top is offset by an angle. Combined entries are separated by forward slashes. Entries are honored in order from left to right. Angle value range is – 85° to + 85° unless a<xx° is encountered.
Total Length (L)	`Positive <numeric value>` Sets overall length of fitting.

Property Option menus are available to assist in making some property entries.